Epson EMP-X56: Projector Lamp Replacement Video Tutorial

Have a look at how to replace the lamp with housing in a Epson EMP-X56 projector. The procedure for other Epson models is often quite similar. In this demonstration, the entire lamp with housing is replaced with a new one. If you have purchased a bare bulb without housing, have a look at the video on replacing bulbs in housing.

Subtitle transcription

  1. Turn off the projector by pressing the Power switch
  2. Let the projector cool down for at least 30 minutes
  3. Unplug the projector
  4. Remove the screws that hold the lamp’s cover
  5. Take off the lamp’s cover
  6. Remove the two screws that hold the lamp housing
  7. Pull out the lamp housing
  8. Unpack the new lamp
  9. Insert the new lamp and tighten it
  10. Return and secure the cover back in its position
  11. Clean or replace the dust filter
  12. Plug the projector in and switch it on
  13. Perform a reset of lamp hours: Menu > Reset > Reset Lamp Hours > Clear the cumulative Lamp Hours "0H".
Send the instructions on to your friends

All of our videos